 |
Description:
- Premium 2" Dual Speed Low Profile Crayford Focuser for Newtonian/Dobsonian reflector telescopes
- Made by Long Perng (same product as Orion focuser), a leading manufacturer of premium telescopes and accessories
- 11:1 fine focus control for backlash free and image-shift free focusing
- Includes integral 2" extension tube for additional back-focus travel if required
- Features drawtube tension adjustment and focus lock screws
- Includes 1.25" eyepiece adapter
- Will fit 8" or larger tubes, as well as flat tube surfaces.
Drop-in
replacement for many Orion Newtonian and Dobsonian telescopes,
including Intelliscope dobs (will not work with SkyQuest XT8 Classic
Orion dob sold before 2007 unless you drill new holes, or some models
of the XT10i). Please use the information below and in the photos to
confirm whether this focuser will work with your telescope.
Specifications:
All
measurements below are measured from the bottom end of the flat base
plate. There will be an additional gap of 1-2mm between this base plate and the
telescope tube which will depend on the diameter of your telescope tube.
- For
use with 2” eyepieces and accessories (without 1.25” adapter):
- Focuser travel range: Minimum Height = 1.89”
(47.9mm) and Maximum Height = 4.54”
(115.3mm)
- Minimum focuser height (with 2” extension tube collapsed) = 1.89" (47.9mm)
- Maximum focuser height (with 2” extension tube
collapsed) = 2.85" (72.5mm)
- Minimum focuser height (with 2” extension tube fully extended) =
3.62" (92.0mm)
- Maximum focuser height (with 2” extension tube
extended) = 4.54" (115.3mm)
- For
use with 1.25” eyepieces and accessories (with 1.25” adapter):
- Focuser travel range: Minimum Height = 1.98” (50.2mm) and Maximum Height =
4.63” (117.6mm)
- 1.25" low profile adapter only adds 2.3mm to the above 2" measurements
- Focuser includes a 1.25” collet that can be used for added extension. This can
add up to 0.85” (21.7mm) to all the above 2” heights. However, it can skew the
optical axis significantly and is not recommended for frequent or imaging use.
- Drawtube travel is 24.5mm
(almost 1"). Integral drawtube extension can be used to add 44mm (1.7")
of additional back-focus travel, so total tube travel is 68mm (2.7")
- Mounting hole pattern is 54mm (2.125") along optical axis and 90mm (3.56") perpendicular to optical axis
- Focuser weight (without 1.25" adapter) = 1lb-10.8oz (760gm)
- Focuser weight (with 1.25" adapter) = 1lb-12.3oz (802gm)
- Focus knob diameter = 1.49" (38mm)
- Microfocus knob diameter = 1.10” (27.8mm)
- Maximum outer barrel diameter = 3.31" (84.0mm)
- Millimeter markings on focuser drawtube: No
- Rotatable: No
- Dust plug: One 1.25" dust plug included
|
|
|
